Precision stamping parts cause cracks in the processing of precision parts such as hard alloy brazing workpieces. There are many factors, such as groove shape planning, brazing process, heating process and sharpening, etc.
1. Some cemented carbides with high hardness and low strength, such as YT60, YT30, YG2 and YG3X, are prone to brazing cracks. Especially when the brazing area of cemented carbide of these brands is relatively large, more attention should be paid.
2. The closed or semi-closed groove shape is an important reason for increasing the brazing stress and promoting the formation of cracks. The brazing area should be reduced as much as possible to reduce the brazing stress while meeting the requirements for the use of weld strength.
3. If the welding heating rate is too fast or the post-welding cooling rate is too fast, the heat distribution will be uneven, and instantaneous stress will cause cracks. When heating rapidly, the outer layer of cemented carbide is subjected to compressive stress and the middle is subjected to tensile stress. When the allowed heating rate is exceeded, visible cracks and invisible cracks may occur inside. During rapid cooling after brazing, tensile stresses appear on the outer layer, causing cracks in the alloy. The workpiece should be prevented from being placed on the wet ground or placed in a wet lime tank, which will cause cracks in the cemented carbide due to sudden cooling.
4. The tungsten carbide strip has its own shortcomings, which cannot be found during the pre-welding inspection, resulting in cracks after brazing. For large-area or special-shaped cemented carbide, it is necessary to strictly check block by block before brazing. The defects of cemented carbide in the sintering process, such as small cracks, chipping, looseness, etc., may expand to form large cracks after heating and brazing.
5. Improper sharpening after brazing can also cause cracks, such as improper selection of grinding wheel materials, hardness and particle size, water cooling during grinding, excessive grinding allowance, improper grinding process, etc. can also easily form cracks .
What are the reasons for the cracks in cemented carbide strip brazing?
Mar 30, 2023
Leave a message






